JLCPCB Prototype for $2(Any Color): https://jlcpcb.com
Final assembly of the PWM5 ThruHole Solar Charge Controller - 3 transistors, a diode, a resistor and the IRF3205 MOSFET. Plus an update on the garden.

By Julian

Youtuber, shed dweller, solar charge controller aficionado

14 thoughts on “Solar charge controller final assembly plus chat – pwm5”
  1. Avataaar/Circle Created with python_avatars bucky king says:

    Just wondering how you prevent back current through the solar panel(mine has preinstalled diodes) effectively shorting the battery when the solar panel voltage is less than the battery? Also what frequency do you use for PWM? Thanks

  2. Avataaar/Circle Created with python_avatars L Stein says:

    Afternoon Sir. I have been wondering why you didn't have the cables come out of one end of the board? That way you could pot it in a clear pot like a film canister. Also, you could hang it cable end down to aid weather resistance.

  3. Avataaar/Circle Created with python_avatars Ciruzzo says:

    I assembly 5 of the circuit but no one work! I did a little of troubleshooting and I find that if I connect a 12V battery to the circuit, the micro controller receive 10V and not 5V. Thinking of the voltage regulator was busted, I replace with a new one….but some thing! I use all the components in description. I checked everything 10 time. I can't find any error. I am using ceramic capacitors. Can this make a difference?

    Thanks

  4. Avataaar/Circle Created with python_avatars Kkathul Gangadharan says:

    Can i get its circuit diagram

  5. Avataaar/Circle Created with python_avatars Thomas Renfro says:

    That is really great, now if you could please give us a true MPPT version that would be wonderful.

  6. Avataaar/Circle Created with python_avatars BEdmonson85 says:

    On the subject of the FET on your desk. I remember a time when you were instructed to solder a wire across all three leads to short them until you have it fully installed into whatever circuit it was going in to, otherwise you'd destroy it just trying to install it. Electronics and ESD protection has come a long way.

  7. Avataaar/Circle Created with python_avatars Anthony Thomas says:

    Would you be able to make a video about the best and safest setup for a camper solar setup?
    Solar + Leisure battery + alternator + starter battery. So you can charge the leisure battery from the alternator whilst driving, from solar otherwise.

  8. Avataaar/Circle Created with python_avatars Mark Giblin says:

    Despite the fact that global warming has been shown to be a natural cycle, people still push the idea.

    One thing to note is that there are on average 2,000 active volcanoes spewing out hundreds of thousands of tons of toxic green house gasses and that the amount man adds to that is pretty much a drop in the ocean.

    So people don;t need to panic, ask yourself, who is making money out of this? More importantly, what are renewable energy projects failing? Any real weather change means more of sun, rain, wind, and all that means more chances to gather energy through hydro, solar PV and Thermal.

  9. Avataaar/Circle Created with python_avatars Ritvik Vaishnav says:

    Julian please do an arduino project video mate
    loved it as always 🙂

  10. Avataaar/Circle Created with python_avatars pixelguy38 says:

    did you try using a mosfet driver for that irf3205? it should make it heat up less since you'd be turning it on and off properly

  11. Avataaar/Circle Created with python_avatars Preproto says:

    Does the charge controller have a way to detect power going through it? Could you output it on serial to a screen and let it read all 3 controllers at once? That would be neat

  12. Avataaar/Circle Created with python_avatars TheChipmunk2008 says:

    define 'good weather'.

    I HATE heat… like a mosfet

    And science doesn't care what you believe lol, as you know

  13. Avataaar/Circle Created with python_avatars Oscar Caetano says:

    hey julian did you remove postbag #137 for some reason?

  14. Avataaar/Circle Created with python_avatars Top Best Talent says:

    Julian llett this is a amazing video great work i'm going to try to build this thanks for creating this video and channel you rock….A+A+A+A+

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.